Installation Guide

Up and running
in under 5 minutes.

No plumber. No drilling. No special tools. If you can tighten a bottle cap, you can install the BidetNorth spray — follow the steps below.

⏱ 5 Minutes
🔧 No Tools Needed
💧 Works on All Standard Toilets
📦 Everything Included
What's in the Box
🚿
Spray Gun Bidet
SUS304 stainless steel, your chosen finish
🔩
Angle Valve
T-valve connector for your toilet supply line
🪝
Wall Holder
Matching finish bracket to mount the spray
📋
Instructions
Step-by-step printed guide included
Four simple steps.
That's really it.
Step 1 - Turn off water supply
1
01
Turn Off the Water Supply
Locate the water supply valve behind or beside your toilet — it's the small oval handle on the pipe coming from the wall. Turn it clockwise until it stops. Then flush the toilet once to clear the remaining water from the line.
💡 The valve usually only needs a quarter to half turn. Don't over-tighten it.
Step 2 - Disconnect supply hose
2
02
Disconnect the Toilet Supply Hose
Unscrew the supply hose from the bottom of your toilet tank by hand — it just unscrews counterclockwise. Have a small towel ready to catch any drips. Set the hose aside — you'll be reconnecting it shortly.
💡 If it's a bit stiff, use a cloth for grip — no tools needed.
Step 3 - Attach T-valve
3
03
Attach the Angle Valve (T-Connector)
Screw the included angle valve onto the toilet supply inlet where you just removed the hose. Hand-tighten clockwise. Then reconnect your original supply hose to the bottom port of the angle valve. The new side port is where your bidet hose will connect.
💡 Hand-tight is enough — no wrench needed. Over-tightening can crack the fitting.
Step 4 - Connect bidet hose and mount
4
04
Connect the Spray Hose & Mount the Holder
Connect the bidet hose to the side port of the angle valve — hand-tighten. Attach the other end to your spray gun. Mount the wall holder next to the toilet using the included adhesive or screws. Turn the water supply back on slowly and check for any leaks. You're done.
💡 Turn the water back on slowly. Do a quick squeeze of the spray over the toilet bowl to test pressure and confirm no leaks at the connections.
You're all set.
Welcome to the upgrade.
That's it — no mess, no plumber, no drama. Your BidetNorth spray is ready to use. If you run into any issues, reach out and we'll help you sort it out.
Need Help? Contact Us
✓
Water supply turned back on
✓
All connections hand-tight, no leaks
✓
Spray gun seated in wall holder
✓
Test spray confirmed working
✓
Enjoy — you're now in the 2 billion club